Feed-through Terminal Blocks Suitable for RTD Connections (2-wire and 3-wire)
The XBUTT double-level terminal blocks reduce space
requirements by 50% over single-level
terminal blocks. These terminal blocks are suitable for 2-wire RTD connections.
The XBUTT Series can be bridged on both levels for
maximum flexibility. Marking can be provided at each termination point.
The XB3UKA sensor terminal blocks reduce installation time by
terminating three-wire devices such as photoelectric and proximity
sensors in a single terminal block.
The upper level accommodates the markable feed-through terminal for
the signal line, while the two lower terminal points
are used for the sensor power supply. The lower two terminal points can
be bridged, reducing your wiring for sensor power.
The XB3UKF 3-level terminal blocks provide three feed-through
signal paths. These terminal blocks are suitable for 3-wire RTD
Ordering Example: (1) XBUTT4 Gray, 6.2 mm (0.24, ¥830